Quantcast

New Soda Stream Bottles - How To Adapt

Aussie Home Brewer

Help Support Aussie Home Brewer:

mark_m

Well-Known Member
Joined
20/3/06
Messages
179
Reaction score
2
Hi All,

I've been using a couple of soda stream bottles for my party keg setup.
Went to Kmart to swap empties & was told bottles supplied are now 400gm, 330gm not available.
Price has jumped to about $19.

On connecting the adaptor & reg, it seems the thread & pin system are different, current soda stream adaptor doesn't depress the pin, so doesn't work. (pictures below, new one on left)

I can't see an obvious work around.

Has anyone else struck this & if so, how did you solve it?

Cheers,

Mark.


SODASTREAM_TOP.jpgSODASTREAM_SIDE.jpg
 

mfeighan

Well-Known Member
Joined
8/3/09
Messages
415
Reaction score
32
Location
Greenwood, WA
i put a thinner washer in mine and it worked well, its all the same thread
 

lukec

Well-Known Member
Joined
23/4/10
Messages
231
Reaction score
69
Mine screwed straight onto adapter and worked perfectly.
 

bradsbrew

Who's up for a pint?
Joined
22/5/08
Messages
0
Reaction score
4
Here is a good thread about it

http://www.aussiehomebrewer.com/forum/inde...54942&st=40

I done the o ring and tube over the adaptor pin and it worked a treat until I swapped the bottle and it had a pin like the smaller ones. So i melted a little ball of silver solder and put it in the tube I placed on the pin on the adaptor and it now works a treat again.


Cheers
 

Latest posts

Top