Hi Guys
First time using a spunding valve so excuse the ignorance. I set up the valve to 10psi using a gas bottle last night (working fine) then attached it to the fermentasaurus. The brew was fermenting nicely (plenty of bubbles in the blow off tube) when I attached it.
When I checked this morning the gauge read 0 psi (picture below).
Should the gauge read 10 psi? Or does it go down to 0 when pressure is released, and rise again to the release point of 10psi? If it reduces to 0 perhaps I saw it after it "spunded" (is that a word??!!!).
Or maybe I've got the set up wrong?
Thanks for your thoughts.
First time using a spunding valve so excuse the ignorance. I set up the valve to 10psi using a gas bottle last night (working fine) then attached it to the fermentasaurus. The brew was fermenting nicely (plenty of bubbles in the blow off tube) when I attached it.
When I checked this morning the gauge read 0 psi (picture below).
Should the gauge read 10 psi? Or does it go down to 0 when pressure is released, and rise again to the release point of 10psi? If it reduces to 0 perhaps I saw it after it "spunded" (is that a word??!!!).
Or maybe I've got the set up wrong?
Thanks for your thoughts.