mschippr
Well-Known Member
Just testing out my gear in preparation for my first AG.
While doing my evaporation test i have been trying to get my burner to be efficient.
I have noticed that adjusting the medium regulator doesnt make much difference to the flame.
The flame is blue and sitting 1mm from the burner bed. 1cm under the pot the flame is red and licking up the side of the pot by 1cm in some areas. Some holes in the burner are going on and off. (FYI its a bit breezy today)
Is this normal? I have tried adjusting the air intake on the spiral burner but it hasn't made much difference either.
Thanks,
MARK.
While doing my evaporation test i have been trying to get my burner to be efficient.
I have noticed that adjusting the medium regulator doesnt make much difference to the flame.
The flame is blue and sitting 1mm from the burner bed. 1cm under the pot the flame is red and licking up the side of the pot by 1cm in some areas. Some holes in the burner are going on and off. (FYI its a bit breezy today)
Is this normal? I have tried adjusting the air intake on the spiral burner but it hasn't made much difference either.
Thanks,
MARK.