Low efficiency-should I sparge with more water?

Australia & New Zealand Homebrewing Forum

Help Support Australia & New Zealand Homebrewing Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
As philrob says, but there is another way, rather than miss the mash out you can combine it with the batch sparge.
Use hot enough sparge water (usually acidified) to heat the batch sparge to nearly 80oC. This gives the benefits of the mash out (better extraction, increased fluidity of the wort...).
There is one other benefit, the wort that was run off to the kettle will still have enzyme activity going on, so any unconverted starch that was washed into the kettle will get converted. As the relatively large amount in the kettle will only be raised a couple of degrees when you add the sparge, the enzymes will continue to work until you start applying heat, at least until you heat the whole kettle full up to the high 70oC's.
Sort of like the process used in a lot of English breweries up until around the 1950's when better temperature control and automation started making continuous sparging much more economical.

The temperature of your sparge water needed to hit say 79oC in the batch sparge can be calculated fairly accurately, might be worth having a play around with.
Mark
 
Hi Tricky,
I am also using a 19l pot. What is the beersmith equipment profile setup
 
Hi Mark, Using the above process for sparging,my last two batches with the same recipe (see below) has as far as i can see delivered 20L at FG 1044 with a 63% BH efficiency ( according to Brew Smith) Just wondering if double milled grain would help with my efficiency?

Pale Ale, Golden Promise®™ (Simpsons) (5.0 EBC) Grain 1 52.6 % 1.34 L
0.60 kg BEST Munich Dark (BESTMALZ) (120.0 EBC) Grain 2 15.4 % 0.39 L
0.37 kg Caramalt (Joe White) (49.3 EBC) Grain 3 9.5 % 0.24 L
0.18 kg Wheat Malt, Malt Craft (Joe White) (4.1 EBC) Grain 4 4.6 % 0.12 L
0.70 kg DME Golden Light (Briess) [Boil] (7.9 EBC) Dry Extract 5 17.9 % 0.45 L
39.00 g East Kent Goldings (EKG) [5.80 %] - Boil 60.0 min Hop 6 28.8 IBUs -
1.0 pkg London ESB Ale (Wyeast Labs #1968) [124.21 ml] Yeast 7 - -
 
Back
Top