Gout
Bentleigh Brau Haus
I have a plastic conical (100Lt) and i need to add two taps before i can brew with it.
I was thinking of tapping a 1/2" BSP and then adding a Hex Nipple thread, and the tap to this.
secondly i thought of using stainless bulkhead, but i dont know how i would be able to hold the inner nut to tighten this on. (my arms will not reach that far inside the conical)
a quick look on ebay found this 1/2" tap for $38 + $9 postage.... does anyone know of an alternative or a better way to go about this?
the wall thickness is about 10mm
conical is from rotamouldings WAconicals
I was thinking of tapping a 1/2" BSP and then adding a Hex Nipple thread, and the tap to this.
secondly i thought of using stainless bulkhead, but i dont know how i would be able to hold the inner nut to tighten this on. (my arms will not reach that far inside the conical)
a quick look on ebay found this 1/2" tap for $38 + $9 postage.... does anyone know of an alternative or a better way to go about this?
the wall thickness is about 10mm
conical is from rotamouldings WAconicals