davidiemma
Member
- Joined
- 11/3/09
- Messages
- 10
- Reaction score
- 0
I have a crankandstein 3D which I mounted between a homemade hopper and baseplate. I put covers on the open sides of the mill to stop grain falling out the sides rather than down through the baseplate into a bucket.
I have seen other setups where the mill is mounted under the baseplate so there is no need to cover the open sides of the mill.
My question is - is it o.k to put covers on the side of the mill or does it clog up? obviously i have not used my setup yet.
Also what are the long "wingnut type" bolts for on the side?
I have seen other setups where the mill is mounted under the baseplate so there is no need to cover the open sides of the mill.
My question is - is it o.k to put covers on the side of the mill or does it clog up? obviously i have not used my setup yet.
Also what are the long "wingnut type" bolts for on the side?