So 50% jw ale?Pratty1 said:Base Jumper Ale 3
OG 1040
FG 1007
ABV 4.2%
IBU 20
EBC 7
25% JW Ale
25% JW Ale
25% Vienna
25% Wheat
Haha, typo.SBOB said:So 50% jw ale?
Ended up filling the 20L cube and still had about 2 or 3 litres of wort left over in the end. I brewed it as if it was a 25 litre batch though, as I figured the hops would soak up a fair bit of wort.Pratty1 said:1.3% AA for 390g into wort will absorb 4.68lts of wort.
You will be lucky to get 20lts if you don't account for the absorption.
And the vegetal note will be hard to hide, surely you have some magnum for the fwh and 80m additions??
Hi Coodgee,Coodgee said:my two IPAs from last week - One with heaps of crystal and one with none, and both hopped late with simcoe and columbus; dry hopped the one with no crystal with 150g mosaic and 50g chinook. The other with 150g chinook and 50g centennial. Both in hop bags in the primary fermenter.
You have me rethining my sparge water pH. I only use ~ 1 - 1.5lts for a rinse so have not worried about adjustment.Coodgee said:Ratio is highly on the sulphates side. 12g gypsum added to mash only. Mash pH adjusted to 5.3 with lactic acid and sparge water adjusted to about 5.7. I am liking the results of adjusting the sparge water pH. Gives a nice crispness.
Well when I say sparge water I mean all additional water in addition to the water used for mashing. I acidify it whether it's used for sparging or not. This all started with a raspberry wheat that I was possibly going to sour with lactic acid after kegging, but I found with the mash and remaining water adjusted to pH 5.2 is was perfect. So I did it again with a Saison with the same grain bill and it is very nice as well. Then took it a bit easier with the IPAs and only went to 5.7. It can be hard to get the pH of tap water right. It gets to the point where all the buffering capacity is gone and the pH drops like a stone and then I am adding water back in. So 5.7 is not based on science it's just under 6 and above 5.2. With regards to how much actual sparge water it can vary from 8 to 17 litres depending on the amount of grain that goes into the mash.Pratty1 said:You have me rethining my sparge water pH. I only use ~ 1 - 1.5lts for a rinse so have not worried about adjustment.
How much sparge water are you adjusting and what are you adjusting that with?
Nah just a pint for me thanks broMardoo said:Steinbrau?
Pratty1 said:hoping to sneak in my first Helles this weekend.
Helles 1
OG 1.043
FG 1.007
ABV 4.8%
IBU 18
EBC 6
80% Pilsner
20% Vienna
Mashed at 63c for 60mins and target pH of 5.4 - not crisp and dry, targeting soft.
Using 100% rain water with very minor adjustment for < 10ppm for each mineral.
90 Min boil
Magnum @ 60mins = 18ibu
Fermented with yeast cake from fake blonde W34/70 ~ 800mls of yeast slurry
Enter your email address to join: