Tri - Clover Fittings

[Crusty]

In case I win lotto & set up my 200lt brewing system ( just for fun ) can someone explain what Tri-Clover fittings I would need for the boil kettle. I assume it would be the same for the other vessels as well. Would you weld this socket end to the kettle & attach this to it then this together with these clamps
Can someone who has these fittings explain them.
Cheers

 

[barls]

you missed the rubber gasket that goes between them
Tri-Clover Silicone Gasket (50.5mm)

basicly i used them but didnt like them too much stuffing around.
cheers barls

 

[punkin]

You can just weld a ferrule straight to the kettle, no need for a threaded one., then gasket, valve and clamp. I don't stock the three piece valves but have some 1/2" one piece ballvalves in triclamp.

http://www.stilldragon.com.au/stilldragon_store.php?view=productListPage&category=14

 

[pmash]

When you win the lotto Crusty, maybe you might head this direction.......with a bit of Braumeister BLING!!! :super:

 

[Crusty]

you missed the rubber gasket that goes between them
Tri-Clover Silicone Gasket (50.5mm)

basicly i used them but didnt like them too much stuffing around.
cheers barls

Thanks Barls.
I did forget about those.
Cheers

You can just weld a ferrule straight to the kettle, no need for a threaded one., then gasket, valve and clamp. I don't stock the three piece valves but have some 1/2" one piece ballvalves in triclamp.

http://www.stilldragon.com.au/stilldragon_store.php?view=productListPage&category=14

Thanks for the tips Punkin.

brau.jpg
When you win the lotto Crusty, maybe you might head this direction.......with a bit of Braumeister BLING!!! :super:

:icon_drool2: