damoninja
Well-Known Member
- Joined
- 9/9/13
- Messages
- 1,380
- Reaction score
- 319
Stemmed from my mini keg build thread
http://aussiehomebrewer.com/topic/94050-mini-keg-esky-build/
Some have been following my compact portokeggy build and asked to check out the possibility of getting some more of these fittings done up, I'll email gascon and get the pricing situation etc.
These are for adapting from a standard CO2 bottle to the mini regulator when you are restricted on height, or for some other reason you need the reg to be orientated 90 degrees.
If you just need to adapt and don't need to save height, beerkat have a perfectly suitable straight one, ask them about it.
These are also not for adapting from soda stream bottles.
The inlet end is a standard type 30 swivel nut with a set nylon surface seal.
The outlet is suited to fit the bigger of the mini keg inlet sleeves. The thread is 5/8"-18UNF with a surface sealing face, you can see the inside of the mini reg sleeve has a silicon washer which is the face of the fitting presses against to make a seal, the fitting is not metal or thread sealing, tape is a no no.
When mounted, it only adds approximately 40mm to the total assembly height opposed to using the straight fitting which adds approximately 90mm, a relatively small saving but if you're seeking to shave as much off height as me you'll
Y'all in?
http://aussiehomebrewer.com/topic/94050-mini-keg-esky-build/
Some have been following my compact portokeggy build and asked to check out the possibility of getting some more of these fittings done up, I'll email gascon and get the pricing situation etc.
These are for adapting from a standard CO2 bottle to the mini regulator when you are restricted on height, or for some other reason you need the reg to be orientated 90 degrees.
If you just need to adapt and don't need to save height, beerkat have a perfectly suitable straight one, ask them about it.
These are also not for adapting from soda stream bottles.
The inlet end is a standard type 30 swivel nut with a set nylon surface seal.
The outlet is suited to fit the bigger of the mini keg inlet sleeves. The thread is 5/8"-18UNF with a surface sealing face, you can see the inside of the mini reg sleeve has a silicon washer which is the face of the fitting presses against to make a seal, the fitting is not metal or thread sealing, tape is a no no.
When mounted, it only adds approximately 40mm to the total assembly height opposed to using the straight fitting which adds approximately 90mm, a relatively small saving but if you're seeking to shave as much off height as me you'll
Y'all in?
