b_thomas
Well-Known Member
- Joined
- 4/2/08
- Messages
- 202
- Reaction score
- 0
Putting this one out there for in hope that someone knows how thread sizes work (1/2", 3/4" etc.). More specifically someone who's bought a 1/2" Stainless full bore 2 piece (Grain and Grape) fitting and connected a Skin Fitting to it.
I'd recently purchased a 1/2" Ball Valve and a 1/2" skin fitting, when I try to thread the Skin Fitting in to the Ball Valve it's too small.
The outside diameter of the skin fitting thread is 17mm. The outside diameter of another fitting that does fit into the Ball Valve is 20mm.
So it appears as though the 1/2" Ball Valve has 3/4" thread. I'd like to be able to buy the correct size Skin Fitting rather than waste another $35.
I'd recently purchased a 1/2" Ball Valve and a 1/2" skin fitting, when I try to thread the Skin Fitting in to the Ball Valve it's too small.
The outside diameter of the skin fitting thread is 17mm. The outside diameter of another fitting that does fit into the Ball Valve is 20mm.
So it appears as though the 1/2" Ball Valve has 3/4" thread. I'd like to be able to buy the correct size Skin Fitting rather than waste another $35.