I posted this in my AHB Blog here but thought I might get more feedback if I posted it here too.
Yet another project in the planning phase; a Portable Party Keg Bar.
After building my coolroom, I had a couple of 75mm panels and off cuts left over that I kept.
The plan was always to build a little chamber to hold 1-2 kegs with a nice bar top on it for social functions.
I've been mulling it over for some time, and I think I've solidified what I want and how to execute it.
The main chamber will hold 2 x 19 litre kegs and will be just high and wide enough to do so. I don't want this thing to be too bulky that would inhibit any potential portability issues.
The top will be interchangeable was I want two possible functions for the unit.
One mode will be two corny kegs with a two tap font on top.
The other will be two conry kegs, one attached to a single tap font, and the other to my beer engine.
The main chamber will be water tight and have a drain at the bottom. This is so it can be filled with ice if required on really hot days, and then drained at the end of the day.
The top, I'm thinking should be a nice wooden top, to give it some eye appeal.
A couple of wheels also to aid mobility.
Anyone done anything similar and can provide any helpful advice before I start cutting ?
Doc
Yet another project in the planning phase; a Portable Party Keg Bar.
After building my coolroom, I had a couple of 75mm panels and off cuts left over that I kept.
The plan was always to build a little chamber to hold 1-2 kegs with a nice bar top on it for social functions.
I've been mulling it over for some time, and I think I've solidified what I want and how to execute it.
The main chamber will hold 2 x 19 litre kegs and will be just high and wide enough to do so. I don't want this thing to be too bulky that would inhibit any potential portability issues.
The top will be interchangeable was I want two possible functions for the unit.
One mode will be two corny kegs with a two tap font on top.
The other will be two conry kegs, one attached to a single tap font, and the other to my beer engine.
The main chamber will be water tight and have a drain at the bottom. This is so it can be filled with ice if required on really hot days, and then drained at the end of the day.
The top, I'm thinking should be a nice wooden top, to give it some eye appeal.
A couple of wheels also to aid mobility.
Anyone done anything similar and can provide any helpful advice before I start cutting ?
Doc