Mantis
Official keg inhaler
- Joined
- 4/3/08
- Messages
- 1,328
- Reaction score
- 3
Mill positioned on base
Attatched and tightned up to see if roller spin freely, and they did
Hole cut in bottom
Top plate for hopper attatched and tightned and rollers still spin freely, so all good so far
Bits for hopper cut out
Supports attatched to sides
Hopper put together and top plate and mill attatched
Base attatched
Done
I also added a slide shutoff and the bottom of the hopper so I can fill the hopper, get the mill going then open the slide. Hopefully this will make the job easier and get the free spinning roller going
Slide open
And closed
Attatched and tightned up to see if roller spin freely, and they did
Hole cut in bottom
Top plate for hopper attatched and tightned and rollers still spin freely, so all good so far
Bits for hopper cut out
Supports attatched to sides
Hopper put together and top plate and mill attatched
Base attatched
Done
I also added a slide shutoff and the bottom of the hopper so I can fill the hopper, get the mill going then open the slide. Hopefully this will make the job easier and get the free spinning roller going
Slide open
And closed