Mills

[cdbrown]

Don't get the old bloke started!

I have a Mashmaster Mill which has geared rollers. Have just recently hooked it up to a motor via a spider coupler. I've seen a 7% increase in efficiency now that the rollers aren't shreading the crap out of the grain like the drill did.

 

[BeerSwiller]

Happy with my monster mill

What do you guys with the mm2 run your roller gap at?

 

[tavas]

What do you guys with the mm2 run your roller gap at?

About 0.9mm. I BIAB so I could go finer.

Factory is around 0.9 - 1.0 mm.

I adjusted with a feeler gauge. You need to ensure you measure both ends of the roll when adjusting, as it will "walk".

Granted a detended setup like Crankandstein have would be a whole lot easier, but adjusting the gap isn't the most difficult thing I've had with brewing, and really only took about 5 minutes. Pretty much set and forget.

 

[sav]

Any fav mills .Battered savs diy mill she is still going strong.Wet the grain the last brew I was amazed on how puffed up the husked were and still increase eff might be a plan in the future.

sav

 

[bradsbrew]

Nothin wrong with a marga if you have a bit over a minute per 1kg. Mines done hundreds of kilos and is running better than ever.

 

[sav]

Nothin wrong with a marga if you have a bit over a minute per 1kg. Mines done hundreds of kilos and is running better than ever.

Is that thing still goin shaga

 

[bradsbrew]

Is that thing still goin shaga

Fcukin oath. So is the granite sink cut out, the lamp table and school desk.