achy02
Well-Known Member
- Joined
- 14/8/08
- Messages
- 145
- Reaction score
- 0
Hi All,Today I tried to fit a 1/2" ball valve to my kettle but cocked up and drilled an inch hole which is not sealing properly. I have used a 20mm silicone washer on the inside and an SS washer in the outside. The kettle is leaking quite a bit. I have done a search and looked online but figured I would ask if anyone else has found an easy solution to fix it. (figuring I can't b the only one out there that's made this mistake)CheersAches