Hole plug - old element hole

[H@wkeye!]

Hi all

Quick and hopefully easy one.

I am changing my brewery up lots. Basically a total overhaul.

I'm moving from 4x2200w elements to 2x5757w elements (HLT and Kettle). Thus i need to close the one extra hole for each. It's from one of these elements, https://cheekypeakbrewery.com.au/2200w-stainless-steel-element-only/. The hole is about 34.8mm. Ideally i'd turn it into a site glass, but not sure how to seal it. Any suggestions?

Cheers
Hawk

 

[clickeral]

Hi all

Quick and hopefully easy one.

I am changing my brewery up lots. Basically a total overhaul.

I'm moving from 4x2200w elements to 2x5757w elements (HLT and Kettle). Thus i need to close the one extra hole for each. It's from one of these elements, https://cheekypeakbrewery.com.au/2200w-stainless-steel-element-only/. The hole is about 34.8mm. Ideally i'd turn it into a site glass, but not sure how to seal it. Any suggestions?

Cheers
Hawk

You could put a weldless bulkhead in, another option is to weld triclamp ferrules on or use a nut and bolt to seal

 

[H@wkeye!]

Hrm, i think i'll have to make it a bit bigger, to 2" and then use a 2" bulkhead. They appear very $$ though

 

[TwoCrows]

https://kegland.com.au/products/2-i...gLCQ7Idah9mZY6e3RH0XGm77ARor6nMQk47zlIm6r4xQe

 

[sp0rk]

This should do the job, you'll just need a 30mm nut to go with them and you can likely use the oring from the element to seal them
The nuts from the elements may even be 30mm, it's worth trying them out
https://www.ebay.com.au/itm/2956398...Id=10047394&merchantid=508437757&gad_source=1