nifty
Well-Known Member
- Joined
- 24/9/03
- Messages
- 409
- Reaction score
- 20
Wow guys, these margas must have changed since I bought mine!
All I had to do was prise the cap off the adjuster knob with a thin flat screw driver (took about 1 minute), undo the bolt on the shaft, remove the spring, slide off the adjuster knob and drill 1 hole then put it all back together :blink: . These mods took me a whole of 5-10 minutes.
I certainly would NOT be banging the shaft and I really don't think the shaft should be removed at all.
But like I said, maybe they have changed since I bought mine.
Hope it all comes together for you all.
Cheers
Andrew
Same for me, but I didn't even take the knob off after removing the cap, I just slid a piece of ply between the knob and the mill and drilled through till I hit the ply.
Use a cheap 1cm spade bit in the drill and away you go..
nifty