Carboy
Well-Known Member
- Joined
- 12/3/09
- Messages
- 288
- Reaction score
- 0
Hi Everyone,
I have one of these 60lt eskies sitting in the garage and I'm thinking about converting it to a double batch mash tun, but on close inspection I noticed that the bung hole has an inside diameter of 24mm and where it's been moulded into the wall is not flat.
Just wondering if I should just drill a new BSP inch hole to keep it smooth and even, or if someone on the forum has used one of these and has a better idea for using the current bung hole in the esky.
Thank you in advance for any replies.
Cheers
Carboy :icon_cheers:
I have one of these 60lt eskies sitting in the garage and I'm thinking about converting it to a double batch mash tun, but on close inspection I noticed that the bung hole has an inside diameter of 24mm and where it's been moulded into the wall is not flat.
Just wondering if I should just drill a new BSP inch hole to keep it smooth and even, or if someone on the forum has used one of these and has a better idea for using the current bung hole in the esky.
Thank you in advance for any replies.
Cheers
Carboy :icon_cheers: