50' Stainless coil - (very) mini bulk buy - Melbourne

Australia & New Zealand Homebrewing Forum

Help Support Australia & New Zealand Homebrewing Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
They seem to be really good quality. Had a go bending mine up and managed to re-coil it to the right diameter, but had some issues trying to bend the lead outs. I either wasn't careful enough (probably, it was getting late) or a tube bender is required for the tighter bends.

So a tube bender is in the mail, and I'll resume working on the coil when it arrives.

The coil after unpacking:

1410305508574.jpg

I didn't do any in progress shots... too busy swearing and sweating.
 
Thanks for the update Mofox1.

Definitely on the cards for me depending on how I go with my ramp times when I finally get a brew on. I bought one of those cheap ass pipe benders that are only really designed for copper, it worked then the dodgy rivet started bending so I replaced it and it's working again with straight tube with a lot effort. good luck and look forward to seeing the final shot.
 

Latest posts

Back
Top