200W MILL MOTOR, big enough

[res]

I'm the proud owner of a Monster mill MM-3 PRO, 3x 2 inch rollers. Up until this point I been struggling along with my drill but the grain group buy fast approaching and I'd like a better solution in place to deal with the mass of grain coming. Very interested in the motor and speed controller offered by Full Pint, http://www.fullpint.com.au/200w-mill-motor-with-controller/ , but not sure how to determine if it will be sufficient for the mill I have.
I could only use my drill if I slowly added the malt while it was running, I need a full hopper solution.

Cheers.

 

[razz]

I haven't read through this thread for a while res but the info will most likely be in there. I think everyone that has purchased the motor have been able to drive their mill.
http://aussiehomebrewer.com/topic/44766-mill-motors/

 

[TheWiggman]

That controller provides torque up to 20 Nm. That's 8kg at a typical 250mm handle, which should be more than enough.

 

[res]

@razz Cheers mate that's one hell of a thread, but super informative, Cheers.
@TheWiggman, cheers mate.