iralosavic
Well-Known Member
- Joined
- 17/10/11
- Messages
- 1,131
- Reaction score
- 21
Finally got my stc1000 temp controller in the mail on Friday. So sent the missus to Jaycar with a list and had it all wired up in a sealed jiffy box the next day. It works exactly as it says and I'm a happy customer.
However, the temp probe is a figure 8 (picture two wires fused together with insulation) shaped plastic butt about 1-2cm long and I can't see this being suitable for inserting into a thermowell.
Any suggestions on a suitable probe + thermowell combo for use in a 25L plastic fermenter? There is a great looking thermowell on beerbelly, but it's 40cm long and wouldn't quite fit
Also, when you buy temp probes are they all wired up using a single wire return circuit like the stc1000 factory one? Ie could I just snip it and rewire it?
Cheers
However, the temp probe is a figure 8 (picture two wires fused together with insulation) shaped plastic butt about 1-2cm long and I can't see this being suitable for inserting into a thermowell.
Any suggestions on a suitable probe + thermowell combo for use in a 25L plastic fermenter? There is a great looking thermowell on beerbelly, but it's 40cm long and wouldn't quite fit
Also, when you buy temp probes are they all wired up using a single wire return circuit like the stc1000 factory one? Ie could I just snip it and rewire it?
Cheers