just starting to get into kegs

Australia & New Zealand Homebrewing Forum

Help Support Australia & New Zealand Homebrewing Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

albear4

New Member
Joined
26/3/13
Messages
1
Reaction score
0
1364288189588.jpgGreetings, Beer Lovers.
my name is Al,i have been brewing beer for a long time,mainly can mix with different sugars & hops. not all have been good
,but i have done a few outstanding brews.
i have been wanting to get into kegging for a while,getting over the cost of set up,it has taken a few years.

i have nearly got all that i think that i require.

fridge,tap& hose,co2 cylinder, & these 4 kegs, a mate of mine cannot pa-take in any alcohol of any sort,gave me this 4 kegs.
i know a regulator is required, & is being looked into.

these 4 keggs are full of beer,question will the beer be ok to drink or not.
i kneed help to identify which ones they are,so i can look for new seal kits.

Many Thanks In advance,

al
 
pin lock are the ones with the little pins on the disconnects and are where only used by coke.most seal kits are interchangable.only the disconnects are different pinlock are red in colour with different colurs on the actual lock where ball locks are black and grey

http://www.youtube.com/watch?v=2VgL9JkjCV4
 
as to whether the beer will be ok to drink or not, depends how long they've been sitting around for, and if the seals are ok? but I figure the only way to be sure is chill em, gas em and taste em. If they're not ok, you should be able to tell straight away.
 
Back
Top