JimInCollie
New Member
I have three (3) iSpindels, use them all the time, and I am delighted with them, but I now have a challenge that I am hoping one of you can help me with.
I use Brewfather as my software which, among other things, receives the iSpindel reports. I have two brews on the go at the moment and therefore Brewfather shows results for:
Brew #2 is in its early stages of fermentation and has a week or so to go
I am no longer interested in the readings from iSpindel #1 and deleted it from the Brewfather screen, as it was distracting. Then I realised I have deleted the wrong one... I deleted iSpindel #2 by mistake!!***
Do any of you know how to get Brewfather to start recording the readings from iSpindel #2 again, without opening my pressure fermenting vessel (Fermzilla All-Rounder) and turning the device off and then on again?
I would be much obliged to anyone who can help.
Many thanks,
Jim
(JimInCollie on this forum)
I use Brewfather as my software which, among other things, receives the iSpindel reports. I have two brews on the go at the moment and therefore Brewfather shows results for:
- iSpindel #1, and
- iSpindel #2
Brew #2 is in its early stages of fermentation and has a week or so to go
I am no longer interested in the readings from iSpindel #1 and deleted it from the Brewfather screen, as it was distracting. Then I realised I have deleted the wrong one... I deleted iSpindel #2 by mistake!!***
Do any of you know how to get Brewfather to start recording the readings from iSpindel #2 again, without opening my pressure fermenting vessel (Fermzilla All-Rounder) and turning the device off and then on again?
I would be much obliged to anyone who can help.
Many thanks,
Jim
(JimInCollie on this forum)