FS : Thermowells, motorised valves, temp controller, font, pot

[andytork]

Found a few more bits when cleaning out and have some leftovers from my brew build

4 x Motorised ball valves , 5 wire, 1/2 full bore stainless $40 each

Thermo wells $25 each (bought a lot initially, and just found another stash)


Temp Controllers 1206D model (heat and cool) $20 - Spec : View attachment c1206-d.pdf



50 litre ally pot with 3 piece valve (50cm wide, 25 high) $50

Andale flooded Chrome 3 way font $80 (no snaplocks, was relined, comes with long small diameter lines)

Will post small parts at buyers cost, or pickup from Boronia 3155

Will be more to come as I finish the cleanout

Thanks

Andy

 

[brettprevans]

Andy if u find a 70L mash tun whilst cleaning up let me know lol.

 

[djar007]

pm sent for the three way.

 

[CosmicBertie]

Whats the length of the thermowell..and the diameter of the hole req?

 

[brewologist]

x2

I need a 100mm weld less thermowell if you have one.

Cheers,

 

[andytork]

Andy if u find a 70L mash tun whilst cleaning up let me know lol.

Stumbled on a 45 litre esky mash tun

Here is a picture of the ball valves (stolen picture from web, but pretty much identical)



They are 5 wire, so two for the motor, and 3 for the open / close detection switches. Stainless of course, food grade

Thermo wells extrude 100mm into vessel, 1/2 hole (not hole to take 1/2 fitting) . Come with nut & washer.

Font has sold, Pot has sold and a couple of thermowells (still have a few)

 

[orangehead911]

how much for the mash tun?