Hi All,
I am selling my unitank & fridge as I am not brewing so often and want to downsize.
Unitank has an approximate volume of 110L and was designed by myself and manufactured by a large local engineering outfit. The tank was electro-polished, pickled & passivated in September 2018.
Fridge is a large commercial skope unit (BME550) that has been fitted with a BrewPi and a greenhouse heater (without the thermostat http://sproutwellgreenhouses.com.au/product/large-tube-heater/) to run the fermentation .
Please note: The tank has not been certified as a pressure vessel. I have carried out FEA on the design with a safety factor of 10 and have pressurized it to 30PSI however this is not commercially a pressure vessel.
Tank Features:
Can post another picture of the tank fully assembled if required.
Location: 3192.
I am selling my unitank & fridge as I am not brewing so often and want to downsize.
Unitank has an approximate volume of 110L and was designed by myself and manufactured by a large local engineering outfit. The tank was electro-polished, pickled & passivated in September 2018.
Fridge is a large commercial skope unit (BME550) that has been fitted with a BrewPi and a greenhouse heater (without the thermostat http://sproutwellgreenhouses.com.au/product/large-tube-heater/) to run the fermentation .
Please note: The tank has not been certified as a pressure vessel. I have carried out FEA on the design with a safety factor of 10 and have pressurized it to 30PSI however this is not commercially a pressure vessel.
Tank Features:
- 100% Tri Clamp fittings with clamps & seals included
- 6" lid with 1.5" Inlet
- 2" bottom port with elbow
- 6 X 1.5" outlets
- 1.5" sanitary sample valve (generic aliexpress)
- 1.5" carbonation stone (https://www.glaciertanks.com/tank-carbonation-stones-cbst-600.html) & ball valve with air fitting
- 1.5" 3 piece ball valve (https://www.brewershardware.com/1_5-Tri-Clover-3-Piece-Ball-Valve-TC15VBALL3P.html?category_id=314)
- 2" butterfly valve (https://www.brewershardware.com/2-Tri-Clover-Butterfly-Valve-Pull-Trigger.html)
- 1.5" thermowell
- 1.5" racking arm (https://www.glaciertanks.com/tank-racking-arms-60-90-degree-rk-90-150-150-6-14.html)
- 1.5" spunding valve (the one from the group buy here)
- 1.5" pressure gauge & pressure relief valve
Can post another picture of the tank fully assembled if required.
Location: 3192.