Dicko72
Well-Known Member
- Joined
- 16/9/10
- Messages
- 63
- Reaction score
- 1
Hi Folks,
I have a strange issue with my Celli's and I wondered if anyone had any suggestions.
About 50% of the time I get an inconsistent pour.
The beer either jets out at an angle or spirals out causing a sort of bubble at the end of the tap.
Sometimes when I first pour it can be OK and then after a few seconds will change to the issues above.
If I close the tap and reopen a couple of times the pour comes more steady.
The weird thing is it happens on all 6 of my Celli's.
Every time I change a keg I run hot PBW through the lines and tap, rinse with hot water, then finish with starsan.
Every 4 months or so I will strip down and lubricate with Lubrifilm.
I serve at around 90KPA.
All my beer lines are identical in length about 50cm.
I split my gas line to 2 x 4 gas manifolds.
Anyone have any ideas? :wacko:
Thanks again!
I have a strange issue with my Celli's and I wondered if anyone had any suggestions.
About 50% of the time I get an inconsistent pour.
The beer either jets out at an angle or spirals out causing a sort of bubble at the end of the tap.
Sometimes when I first pour it can be OK and then after a few seconds will change to the issues above.
If I close the tap and reopen a couple of times the pour comes more steady.
The weird thing is it happens on all 6 of my Celli's.
Every time I change a keg I run hot PBW through the lines and tap, rinse with hot water, then finish with starsan.
Every 4 months or so I will strip down and lubricate with Lubrifilm.
I serve at around 90KPA.
All my beer lines are identical in length about 50cm.
I split my gas line to 2 x 4 gas manifolds.
Anyone have any ideas? :wacko:
Thanks again!