Hey all,
Finally got my brew rig built and am on the testing/electrics phase of the project.
Trying to work out and setup my Auber PID SYL-2352P.
I cant seem to get it to do what I think it should.
I have changed a couple of settings, mainly to get it to celcius, and i think i changed the HY from .3 to .1 based on a thread here somewhere.
Im really struggling with the programming of it. Im just trying to do basic things to test.
I need an example... Say ambient water temp is 13 degrees. I want a simple test program to heat from ambient temp to say 25 degrees then hold there for 10 mins.
Step1 - C10 (anything lower than current reading?) T (not sure what time to put on initial step
Step 2 - C25 T10 (25 degrees, hold for 10 mins)
Any ideas what im doing wrong? Im sure it simple, i just havent got my head around how it wants me to program it.
Also when am i suppose to run the auto tune? near a temperature i want to mash at?
Or while its new, an autotune near ambient so it knows the basics of how much it can heat/how long then run it again when its around mash temps?
Also anyone have a list of standard settings for us brewers running an ssr and heating element.
Thanks heaps, Slowly getting setup.
Finally got my brew rig built and am on the testing/electrics phase of the project.
Trying to work out and setup my Auber PID SYL-2352P.
I cant seem to get it to do what I think it should.
I have changed a couple of settings, mainly to get it to celcius, and i think i changed the HY from .3 to .1 based on a thread here somewhere.
Im really struggling with the programming of it. Im just trying to do basic things to test.
I need an example... Say ambient water temp is 13 degrees. I want a simple test program to heat from ambient temp to say 25 degrees then hold there for 10 mins.
Step1 - C10 (anything lower than current reading?) T (not sure what time to put on initial step
Step 2 - C25 T10 (25 degrees, hold for 10 mins)
Any ideas what im doing wrong? Im sure it simple, i just havent got my head around how it wants me to program it.
Also when am i suppose to run the auto tune? near a temperature i want to mash at?
Or while its new, an autotune near ambient so it knows the basics of how much it can heat/how long then run it again when its around mash temps?
Also anyone have a list of standard settings for us brewers running an ssr and heating element.
Thanks heaps, Slowly getting setup.