4V Herms System With Pump, 75L Blichmann Boilermaker kettle but no mash tun

[Hoploader]

Hi all selling my lovely 4V system due to not brewing.

Consists of

75L Blichmann Boilermaker kettle. Cost nearly $800 on its own. Has one tiny dent on edge of base seen in photo from outside and also near brush tip on inside. This was from slip while cleaning. Otherwise is as new basically.

$400

70L Techni ice esky

SOLD

50L Birco urn as HLT with cam locks

$100

20L urn as Herms with copper coil with cam locks

$120

March pump in "enclosure" with cam locks

$50

Brew controller in enclosure with 2 x 240V in for separate circuits for 2 urns. Both urns have thermocouple feedbacks to seperate temperature controllers. HERMS run via RTD to Auber RTD step controller.
Silicone hoses with cam locks and integrated RTD.

$200


Sydney Hills District

Cheers

 

[Hoploader]

50L Birko urn now sold

 

[Hoploader]

March pump now sold

 

[Hoploader]

20L urn and chiller coil now sold

 

[Hoploader]

Kettle now sold.
Brew controller still available for $150

 

[Thor]

Hi - do you have more info on the controller? Picture if possible? THanks.

 

[Hoploader]

Sorry mate I'd not opened this up for a while. I thought I'd entered photos but seems not.
Controller has 2 different types of Omron E5... Controllers I used to run thermocouple for setting temperature of 2 urns. One of these urns ( in my case a 20L HERMS) then would be controlled via an Auber SYL-2532P controller to run whatever step mash program you entered into it for your mash cycle. Temperatures, timers for all steps.
It has 2 separate 240V into enable 2 different power circuits to power 2 urns.
3 240V output leads for urns, though only 2 in use depending if heating Herms or mashing. Pump is also powered from it and has on off switch.