Hey all,
About to get back into brewing/kegging after about 12 months off.
Stripped the brewing rig down, cleaned everything now working on the kegerator.
Replaced all the gas lines, and am about to replace all the beer lines.
I have all perlick 650ss flow control taps, How much beer line should i be using if i have flow control?
Does it matter?
I probably had around a meter previously.
I run the keezer at 2 degrees.
Also I have problems over summer with the beer lines warming up quite quickly as i have a 4 tap font on top of the keezer.
Does beer line length affect this?
Without flooding the font, is the only decent way of cooling it down to put a fan and pipe up into the font?
Thanks all, looking forward to getting back up and running again!
About to get back into brewing/kegging after about 12 months off.
Stripped the brewing rig down, cleaned everything now working on the kegerator.
Replaced all the gas lines, and am about to replace all the beer lines.
I have all perlick 650ss flow control taps, How much beer line should i be using if i have flow control?
Does it matter?
I probably had around a meter previously.
I run the keezer at 2 degrees.
Also I have problems over summer with the beer lines warming up quite quickly as i have a 4 tap font on top of the keezer.
Does beer line length affect this?
Without flooding the font, is the only decent way of cooling it down to put a fan and pipe up into the font?
Thanks all, looking forward to getting back up and running again!