Phoney
Well-Known Member
Good evening gentlemen,
I seem to have a recurring problem with my grain mill where the free spinning roller - the one not attached to my drill - won't start spinning on its own accord when I begin pouring grain into the hopper. I can give it a bit of a kick start with a wooden chopstick and that gets it going, but the ongoing issue is giving me the shits. I shouldn't have to do that!
I've tried re-adjusting the rollers, taken all of the screws out and put them back in, Ive tried setting the gap to 1mm and to .5mm but it's still playing up.It's a no-name brand mill that I bought new from a HBS via AHB a few years ago. Though it's only started doing this fairly recently.
Any other suggestions?
Cheers
I seem to have a recurring problem with my grain mill where the free spinning roller - the one not attached to my drill - won't start spinning on its own accord when I begin pouring grain into the hopper. I can give it a bit of a kick start with a wooden chopstick and that gets it going, but the ongoing issue is giving me the shits. I shouldn't have to do that!
I've tried re-adjusting the rollers, taken all of the screws out and put them back in, Ive tried setting the gap to 1mm and to .5mm but it's still playing up.It's a no-name brand mill that I bought new from a HBS via AHB a few years ago. Though it's only started doing this fairly recently.
Any other suggestions?
Cheers