Hi Guys,
I have been setting up my keg system in my fridge, and now i am up to finishing up the gas side.
So far i have 1 nitto connection going into the fridge, and it passes the bucket of water test.
What i was thinking of doing is setting up a manifold with 4 nitto sockets, then have the nitto (male) connected to a check valve, followed by the ball lock disconnect.. with a bit of hose...
This should give me a gas setup with sealing on both sides of the connection for easy swapping and rearranging.
Does anyone use these?
How do they hold the low pressure?
Thanks.
I have been setting up my keg system in my fridge, and now i am up to finishing up the gas side.
So far i have 1 nitto connection going into the fridge, and it passes the bucket of water test.
What i was thinking of doing is setting up a manifold with 4 nitto sockets, then have the nitto (male) connected to a check valve, followed by the ball lock disconnect.. with a bit of hose...
This should give me a gas setup with sealing on both sides of the connection for easy swapping and rearranging.
Does anyone use these?
How do they hold the low pressure?
Thanks.