Help Support Aussie Homebrewer by donating using the link above.

Keezer, Kegs, CO2 complete setup Brisbane

Discussion in 'Buy and Sell' started by MrGilly, 11/6/18.

 

  1. MrGilly

    New Member

    Joined:
    17/2/17
    Messages:
    4
    Likes Received:
    0
    Posted 11/6/18
    Keezer built with all quality fittings, very little use and all components about a year old apart from the chest freezer.

    PLEASE SEE ALBUM OF PICS HERE

    Chest freezer is a 164L Fisher & Paykel, in good condition with plenty of years service left. Also able to be converted back to a chest freezer as wiring has not been modified and temp controller just runs in line with power cord.


    Keezer was built using the following components, total build at the time cost over $1000:

    - Top quality Krome Dispense stainless taps - were around $100 each

    - 4 tap gas manifold splitter, with separate valves and backflow prevention check valves to each line.

    - 2 kegs in near new condition, always thoroughly cleaned and well maintained.

    - CO2 Bottle and Regulator - bottle has only seen one refill since new. Currently empty.

    - Elitech STC-1000 Temp Controller built into Jaycar Box. Works great.

    - Thick pine wood collar.


    Keezer will fit more kegs and taps, and plan was always for expansion which is why a 4 way manifold etc was used. All relevant gear purchased from the Loose Moose Brewing Co in Browns Plains.

    Regretful sale. Not looking to separate/part out. Selling as complete.

    Located in Cedar Grove. $650 ONO

    cheers
    Mark
     
  2. mahonya1

    Well-Known Member

    Joined:
    13/10/09
    Messages:
    109
    Likes Received:
    5
    Posted 12/6/18 at 11:08 AM
    Hi Mark. Will it fit more 19l kegs in or have to use the smaller 9l kegs? It looks tight with the compressor bump
     
  3. MrGilly

    New Member

    Joined:
    17/2/17
    Messages:
    4
    Likes Received:
    0
    Posted 12/6/18 at 11:33 AM
    Hi, I'll check it out for you in the morning and take some pics.
     
  4. MrGilly

    New Member

    Joined:
    17/2/17
    Messages:
    4
    Likes Received:
    0
    Posted 12/6/18 at 11:56 PM
    Fits no problems! Sits just under the collar with room to spare. I've updated the album and added a couple of pics for you.

    cheers
    Mark
     
  5. MrGilly

    New Member

    Joined:
    17/2/17
    Messages:
    4
    Likes Received:
    0
    Posted 14/6/18 at 10:39 PM
    Sold pending pick up.
     

Share This Page