Killer Brew
Well-Known Member
- Joined
- 25/12/14
- Messages
- 705
- Reaction score
- 235
Wanting to dip a toe in the water of kegging and managed to cobble together a mix of equipment from mates who had extras. All i needed to get was a gas and beer push on connections for the corny keg i was given. Cleaning out the keg today with some hot water and thought i would run some through the lines to test everything out.
Gassed up just fine however on the out side i'm not getting any liquid through into the tap lines. If i push in the out valve the water hits the garage roof so pressure is there! I pulled apart the coupler, put back together, pushed on as firmly as possible....still nothing. Im assuming a faulty coupler but is there anything else i should consider before i take it back to the LHBS and request a replacement?
Gassed up just fine however on the out side i'm not getting any liquid through into the tap lines. If i push in the out valve the water hits the garage roof so pressure is there! I pulled apart the coupler, put back together, pushed on as firmly as possible....still nothing. Im assuming a faulty coupler but is there anything else i should consider before i take it back to the LHBS and request a replacement?