Co2 Line Splitter/manifolds

[TryAgain]

I'm just trying to get a kegging setup put together and it has all been pretty smooth sailig apart from getting the CO2 line splitter attatched. I've got it all together, with the gas hose attached to feed each keg but I can't for the life of me get the little plastic plug off the other end of the manifold where the hose from the regulator should attach to the manifold.

Has anyone else had a smiliar problem, and if so what did you do to get the little ******* out?

 

[jbirbeck]

if you're talking about the ones that can click together like These then you should be able to pull out the stopper after you've taken the little blue clip in allowing a section of the splitter to be pushed in thereby releasing the lock on the stopper

Then simply click together and replace the blue clip once youre locked in

 

[TryAgain]

Yup those are the ones, I've pulled the little blue ring off but can't get the clearish plastic plug out, even using pliers!

 

[syd_03]

Yup those are the ones, I've pulled the little blue ring off but can't get the clearish plastic plug out, even using pliers!

Push the white collar in and hold it in while you pull the plug out.

 

[TryAgain]

Yup that did the trick thanks for that, it's all working now, amazing how tight they are held on until u release the collar, chewed into the plastic pretty badly, but its there now!

Push the white collar in and hold it in while you pull the plug out.