1hp Electric Single Phase Motor - 2830rpm

[roller997]

I bought this brand new off Ebay to run a large Crankandstein mill.

It cost me $112 including shippment.

Identical unit to the following and purchased from this supplier:

http://cgi.ebay.com.au/BRAND-NEW-1HP-240v-...=item43a6d37df8

Motor is in perfect condition and I just tested it for 30 seconds to ensure it is not DOA before ordering pulleys. It runs quite smooth and quieter than the replacement motor. As I have limited space, trying to get a 10:1 ratio was going to be too big for me so I purchased a much more expensive motor running at slower speeds and SWMBO noticed I have two of them. Now this one has to go......

I am willing to sell it for $80 and I would prefer local pickup or CBD pickup. Alternatively if I get no local interest, I am happy to ship the motor at your cost.


It was purchased 26th of February, so there is plenty of warranty left on the motor.

Shaft is 19mm and keyway is 6mm.





Cheers



Roller

 

[roller997]

Looks like there may not be any local interest - I am happy to consider interstate shippment.
I will ship the motor at cost and if it is more than $20, I will cap it at $20.

Regards

Roller

 

[roller997]

Thank you for fellow homebrewers expressing interest.

The motor as been sold.