MillMaster MiniMill

[neal.p]

Hi,
One of the eccentric adjustors on my mill came off. I looked on the interwebs and the MashMaster website and couldn't find any instructions. The adjustor is eccentric so I figure it needs a particular orientation so the roller is in an OK position before tightening the side-locking pin?

There is some grease in the adjustor as well

 

[Hpal]

You should be able to just put it back on and tighten it up, I wouldn't think any alignment necessary

 

[huez]

Put it back in, adjust the roller gap and tighten it back down. You must have unscrewed the lock pin to far which allowed it to come out. If you email mashmaster he generally gets back to you the same day.