These are all new bottles (BURP), and have the red seal.
My process :
1. Empty bottle into a glass.
2. Drink beer.
3. Rinse the bottle. This is water from an old barrel - has a tap. The "Water" is sterilisation liquid - cannot remember the name, but it takes two hours.
4. Confirm no dreg.
5. Rinse the bottle again, and fill with 2inch of "water"
6. Reseal.
7. Next day / whenever, empty the "water" out, reseal.
Bottling :
8. Open bottle, pour out the little bit of "water"
9. Fill
10. Seal
11. Goto 1.
Quicker in the sense that I have to rinse the bottles anyway. Then I have to store them, then I have to sterilise them, then I have to cap them.
1. Open a bottle.
2. Fill bottle
3. Whilst bottle is filling Open a bottle
4. When bottle is full, swap with the empty bottle.
5. Cap the full bottle.
6. Goto 3
The only issue that I had last night was that I had no spare moment to drink beer. I had to stop filling to get a drink! Takes about the same amount of time to cap and open a bottle as it does to fill it