Kettle heating element wire burnt out - is my element cactus?

Australia & New Zealand Homebrewing Forum

Help Support Australia & New Zealand Homebrewing Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

mr_wibble

Beer Odd
Joined
21/1/09
Messages
1,114
Reaction score
231
Location
Lake Macquarie NSW
G'day,

My kettle failed to heat water past 35C when I turned it on yesterday.
It worked fine 2 weeks ago (last time I turned it on).

So I open up the connector box to find one of the wires has burned out:
failed_wiring.jpg

The wire is 4mm conductor rated to 20A, 4500w element at 240V ≈ 19A.
It is within specifications in terms of load.

Is this sort of failure caused by the element, wiring, or something else?
Perhaps it was not getting a good connection to the terminal.

Is the element probably going to be cactus?

I guess I can re-wire it this afternoon, but would like to order a new element ASAP it it's going to be stuffed.

thanks,
-kt
 
Mostly its caused by a bac connection between the wire and the element, a drop of water/wort/condensation can lead to a bit of corrosion which causes increased resistance and creates a hot spot.
I like to crimp the wire into an appropriate copper or brass connector, clean the contact point on the element and tighten it up. You can get a paint/paste type stuff that will keep water out of the joint, might be worth asking an electrical supplier what they have available, I know its often used in control boxes and on electrical contacts around swimming pools.
Odds on the element is fine.
Mark
 
Cool, thanks for that.

It's going to be a PITA to disassemble it and repair.
Guess I wasn't planning to brew this weekend anyway.
 
Back
Top