Ok so I finally have all of my gear for building my first kegerator.
The fridge I'm using is a Fisher and Paykel P120 bar fridge:
Which, after some manifold and temperature control unit manipulation fits two 19L corny kegs comfortably side by side. It does not, however, fit a CO2 bottle AND both kegs so I'm left with no alternative but to drill some CO2 lines.
The obvious tricky part is where to drill the lines. I have felt the fridge when it's running and it's definitely hot in some spots on the sides and top. I'm assuming there is some sort of cooling line here but buggered if I know where. I know that I can make a paste up of rubbing alcohol and corn flour to find out, but just wondering if anyone has used this fridge? How and where did you drill the lines?
Everything else seems pretty straight forward but can't really make a start until I drill these lines!
The fridge I'm using is a Fisher and Paykel P120 bar fridge:
Which, after some manifold and temperature control unit manipulation fits two 19L corny kegs comfortably side by side. It does not, however, fit a CO2 bottle AND both kegs so I'm left with no alternative but to drill some CO2 lines.
The obvious tricky part is where to drill the lines. I have felt the fridge when it's running and it's definitely hot in some spots on the sides and top. I'm assuming there is some sort of cooling line here but buggered if I know where. I know that I can make a paste up of rubbing alcohol and corn flour to find out, but just wondering if anyone has used this fridge? How and where did you drill the lines?
Everything else seems pretty straight forward but can't really make a start until I drill these lines!