I've decided to go down the arduino controller path for BIAB and need a bit of help selecting the right parts.
I will have:
Crown urn for heating
12v DC pump for recirculating during mash
12v DC pump for immersion chiller
The arduino bits are where i need help.
So far i have:
1 x Arduino Uno
1 x power supply for Uno
1 x DS18B20 temperature probe/sensor
1 x 1602 LCD display with push buttons (to allow me to set different hop schedules etc)
I'm unsure which SSR's I will need to switch the pumps on and off. A link to a specific model would be great!
Do i need seperate power supplies for each pump as well or can they run off the arduino power?
Cheers
I will have:
Crown urn for heating
12v DC pump for recirculating during mash
12v DC pump for immersion chiller
The arduino bits are where i need help.
So far i have:
1 x Arduino Uno
1 x power supply for Uno
1 x DS18B20 temperature probe/sensor
1 x 1602 LCD display with push buttons (to allow me to set different hop schedules etc)
I'm unsure which SSR's I will need to switch the pumps on and off. A link to a specific model would be great!
Do i need seperate power supplies for each pump as well or can they run off the arduino power?
Cheers