Where To Drill
- Thread starter huntsy
- Start date
Help Support Australia & New Zealand Homebrewing Forum:
litre_o_cola
Well-Known Member
- Joined
- 27/12/08
- Messages
- 124
- Reaction score
- 1
Depends on the fridge for starters, for the tap just see if it has a switch for the butter compartment in the door.
With the gas line look around the thermostat area and you should be able to see any wires in the cavity, just push the insulation around to check for wiring ie. light, earth and thermo.
Pics will help heaps as someone may well have the same fridge on here.
With the gas line look around the thermostat area and you should be able to see any wires in the cavity, just push the insulation around to check for wiring ie. light, earth and thermo.
Pics will help heaps as someone may well have the same fridge on here.
wyatt_girth
Well-Known Member
- Joined
- 4/2/08
- Messages
- 293
- Reaction score
- 0
The door of my fridge had nothin but hinges connecting it to the unit, but I proceeded with caution anyhow. For the tap hole I just eased through the inner plastic lining, poked around a little and cut the foam away with a screwdriver - then stanley knife before drilling the rest of the way. Same deal with the gas line hole except I put it throught the side of the fridge. Start form the inside and take a look around before rippin in.
