Recent content by rafinus

Looks great...

One more for silver. My vessel I will use outside and when have the sunlight I think the transparent one is not good to see. Grate job Lael.

Very nice Lael....cheers

Thanks a lot...

Thats what happen...and I configure the entire unit parameters...

Yes, and try a lot of combinations.

Hi guys, Yesterday I made a batch and figure out that the sensor in the chiller time doesn't work again. I use a immersion chiller and the temp in arduino mark like 35C and the real temp inside the vessel was 24C. Any tip? PS: I bought another DS18B20 to test when arrive. Thanks,

I´m from Brazil too, where you from?

Lael, in Brazil is 10A, but for instance to me, I using a 4400w element (that at 220v is 20A, is the domestic/commercial limit in Brazil), than I made an extension cord (4mm triple wire) and plugin direct in my electrical panel using a 32A switch and sockets. Thanks for the effort.

This one? /* * EEPROM Clear * * Sets all of the bytes of the EEPROM to 0. * This example code is in the public domain. */ #include <EEPROM.h> void setup() { // write a 0 to all 512 bytes of the EEPROM for (int i = 0; i < 512; i++) EEPROM.write(i, 0); // turn the LED on...

Yes, I set all de parameters. How I can wipe the eeprom?

Lael, I do this, but in my system if in the boil phase I set the pump ON, it lost efficiency and the temperature it takes too long to reach. Why don´t work?

Yes, the first attempt 0,00, then 1, 2, 3..until 5, but without success. And negative to, -1, -2...

Hi guys, I have a little problem or I don´t know what happens. I just update my system to this new version of ArdBir (ArdBir_2_6_70b7) and I try to do the most accurate config but without success (or close). In resume, the only thing I don't get is when in the boil, if the pump doesn't work...

I need 20amp to, I have a 4000w element...