Help Support Australia & New Zealand Homebrewing Forum:
-
-
NNattyJ reacted to Bilambil Bill's post in the thread Returning to home brew after 20 years or so with
Like.
Hello. I home brewed on and off for about 20 years until I ran out of spare time about 20 years ago. Mainly extract with partial grain... -
NNattyJ replied to the thread Bottle Storage..I stored them in milk crates and then just had a sheet or two over them. I also had some in sealed storage boxes from Bunnings. It...
-
NHUB are very pleased to announce the full line up of sponsors, prizes pool and entry particulars for this years Hunter Brew Comp, which...
-
NNattyJ replied to the thread First time brewing need help.As stated below, it'll be fine. Just be careful of stirring lots until dissolved so it doesn't sit on the bottom and scorch. Good luck...
-
NNo, it shouldn't be that way. But you can still use it. Don't worry if it does not dissolve completely, the yeast will still eat it...
-
NNattyJ reacted to bigmunchez's post in the thread yeast washing and sodium metabisulphate with Like.
I'm pretty sure that the metabisulphite dose used to remove chloramine/chlorine (1/4 tab per 20L) is way less than the dose used to halt...
-
NNattyJ reacted to JDW81's post in the thread First time brewer question - Has my brew stalled? with Like.
A gravity of 1.011-12 is about right for an ale, and If the gravity is stable of 24-48 hours then fermentation is likely complete. I...
-
NAre you guys planning on releasing just the head of these as a replacement for people who already have the original 25W pumps (or...
-
NWe did not have plans on doing this but if we get enough requests anything is possible.
-
NIn this case I think installing an element in my existing kettle will be cheapest and fairly straight forward, and I already have an...
-
Nthe barb & nut part alone would likely be $4 from most outlets, then another $6 for a fairly complicated injection moulded part? Seems...
-
-
Loading…
-
Loading…