Recent content by nacnud

Thanks Ben, I had wondered if that was my issue. That's why I went to using off the shelf grain bills. Didn't solve my problem unfortunately. I think it must be infection. I just need to work out where it's coming from. Cheers

Thats a good idea. I'll give averything a major clean with a different steriliser and then try a coopers kit. If that goes bad then it'll be new fermenter, hoses etc and another coopers kit. Thanks for your advice everyone.

I'm just using a 30ish L plastic fermenter with an airlock and screw in tap. Fermenting in a temperature controlled fridge. Last brew was an IPA. Went from 1.062 to 1.008 over a couple of weeks. 2x US-05 rehydrated in 2 cups of room temp water. Pitched at and set to 19 degrees. Was bubbling...

I'm in Perth. Yeah, maybe I should take a bottle into the brew shop. If it's an infection, wouldn't it be noticeable immediately after fermentation? Somehow it's happening under CO2 and at 4 degrees...

Yeah I'll try a new fermenter next time and some different sanitiser. You're right, I did have my sterilisers mixed up. What I'm using is the local homebrews brand, just labelled No Rinse Steriliser (Sodium Percarbonate) and Keg and Line Cleaner (Oxygen bleach and sanitiser). Kegs are sweet...

HI Kadmuim, I use Sodium Metabisulphate for kegs and lines, pull the posts off , tubes out and soak the lot each time. I sanitise everything else with Sodium percarbonate (no rinse). I transfer with silicon tube straight from fermenter to keg. It also gets a soak in no rinse steriliser. The...

Hi all. I have been brewing for the best part of a decade now but over the last couple of years I have brewed very few beers that I've enjoyed. The problem is a strong sweetness that comes on after kegging or bottling in almost all of my brews. The beer tastes great at the end of fermentation...

Anybody know what's happening with this years WASABC? I can't find anything on it :huh:

I get small pockets, maybe 1-2cm max in the lines right up by the taps - it's a chest freezer with wood collar setup. But I get that in the tap that pours just fine too. I've tried pulling them apart and cleaning them out but have never replaced seals. Could that really cause foaming? It's not...

Hi guys. Ive had three pretty basic keg taps for about a year now and two of them have developed a pouring issue. When the tap is fully opened the flow seems to be slightly obstructed and I just get foam. There seems to be a sweet spot just short of fully open that pours normally. I'm pretty...

Yeah. the JG fittings might be a good solution. Does anyone know if they have much of an affect on resistance in the beer line? How about these things? http://kegking.com.au/in-line-regulator.html Apparently they do gas and liquid so could put one each side of keg. Cheap option maybe?

Hi, I've been kegging for a few months now with a single regulator connected to 3 kegs with 3 identical length beer lines all sitting at a middle of the road serving pressure. I'm now looking at upgrading a little by adding 3 secondary regulators so that I don't have to have my Stout just as...

Thanks for the suggestions. I've unscrewed the disconnect for now as Rudi suggested and will be investing in a carbonation cap or spray bottle setup for next time. Both good solutions! Cheers.

I have a PET bottle but no carbonating cap. How would that work?

Yesterday I put together a disconnect-picnic tap setup for filling bottles from a keg so that I can take a few to a mates place or whatever without the hassle of a counter-pressure filler. Seems to work well but now I have a dirty beer line and no empty kegs to push cleaner/steriliser through...