One of a kind gas powered direct fired RIMS brewery. For the brewer who wants full control. It features quality parts and workmanship inspired by the best design features from "Brutus 10" and "theelectricbrewery.com". I built this from the ground up based on months of research, planning and...
I asked WC for a water test report representative of Duncraig, thinking I would receive Whitfords, and I received Yokine. Here it is.
It's amazing how variable the water is comparing Whitfords and Yokine in the annual report
I have these same controllers (labelled rkc Rex c100), setup with pt100 rtds, and was experiencing the same glitch. Changing df to 0 fixed it. Thanks!!
Also I have 1 decimal place with these probes, but on another controller with a k thermocouple it has 0 dp.
Hi guys. I've built up a iSpindel circuit board using "stripboard", all seems fine. Not as pretty as the pcb, I'll probably order this at some point.
Now it's time to get it working. I managed to flash it using Node MCU, and in a terminal window I can see:
NodeMCU 0.9.5 build 20150318...
My clone attempt turned out as a nice beer, although it certainly wasn't a Two Birds Sunset Ale, unfortunately. The flavours from the crystal malts were far too strong, and the hop flavour was also a bit rich. It didn't end up being the easy drinking summer beer I was hoping for!
If I were...
Kegged my clone attempt the other night. The smell coming out of the fermentor was pretty amazing, litterally smelt like tropical fruit juice! Taste was delicious, nice and fruity. Doesn't have the nice malty/biscuity taste of the Two Birds Sunset Ale yet.
Will be drinking the final product in...
Had a crack at the recipe and brewed it last weekend, my recipe is below. Not sure if i went for enough Vienna Malt. The Citra smelt amazing. It's in the fermenter now and will be going into a keg in a week or so.
Recipe Specifications
--------------------------
Boil Size: 43.06 l
Post Boil...
My little brewery in action:
Next upgrade is refinement of the temperature control, and re-calibration of the volume sight glasses.
Then, I'll be building a stand for the whole set-up.