I eventually got the PCB's but was about 4 weeks. Must have been some hold up ... oh well they arrived but were just thrown in a bag with no padding etc and were rattling around when they arrived. One had some minor damage but it isn't enough to make the PCB unusable.
Cheers
F
ok, I fired this up tonight and noticed that the Tilt sensor wasn't reporting any values. The temp sensor seemed to be checking in ok though. Noticed that I hadn't followed the instructions to remove the diode on the Wemos...did this and now nothing works :) This is mentioned in the German...
Rainy Sunday here today so decided to tackle the first iSpindle build. I have most of the components, minus the battery and weights.
IMG_4825 by farsonic posted 15/10/17 at 7:06 PM
IMG_4828 by farsonic posted 15/10/17 at 7:06 PM
IMG_4830 by farsonic posted 15/10/17 at 7:06 PM
IMG_4831 by...
I got my cradles/sleds printed on 3DHubs and specifically used Kerry's Hub as the person doing the printing. This guy was fantastic and responded within minutes of me uploading my print request. He ran an initial test print on the sled to make sure it would work before committing to printing...
Just ordered some PCB's for this .... do you happen to have the parts list needed? I'll look to build a few of these :)
Ordered most of the components tonight also.
I'm horribly confused over which containers to order and what the matching sled is I'd need to get printed.
Can anyone suggest...
Can I use a standard solid state relay for this or do I really need to use a larger mechanical relay for controlling a Crown Urn? I have a few sainsmart 4 port relay boards I could use for this purpose? Any thoughts?
FP
I think we all second the suggestion by Stu! I have a huge cathedral ceiling where the bar is, so it is going to a bit of an engineering challenge....
I've emailed the manufacturer of the fridge asking for a manual and will try and get a look at one of these before purchasing and will probably...
My existing home bar area is in line to be completely ripped out an replaced. I'm thinking seriously about putting in a 3 door commercial fridge, something like this -> http://acesolutions.com.au/three-door-stainless-steel-bar-cooler/
This is going to take up 80% of the under-bench space that...
Have drilled a new hole for the temp probe and going to simply leave the urn at maximum. This way I can see how it goes and keep the protection circuits in place for the Crown element. Will see how this goes and then if needed make some modifications later. Now, to try and screw this temp probe...