The disconnects and posts are NOT interchangeable. Liquid is for liquid. Gas is for Gas.
The carbonation caps are the ones that are interchangeable....
It was actually one of the best beers I have made and I have had it on the "to brew" list for a while. Granted back then my palate and brewing abilities were less developed than they are today, but I am keen to brew it again when there's a slot in the fermentation cycle.
Yeast would have been...
@KegLand-com-au any chance of you selling the flexi-arm seals as replacement spares? First mash I did I dropped the seal into the mash bed (got it at the end) as these fall out very easily, I’m certain I’ll lose some along the way so good to have a bag of them handy please.
Also any updates on...
My mate checked and said there was no ice at all!
Is there a small font fan to blow up the tube? Or does it just take a tiny bit of air from the main large fan to blow up the tube? My mate said upon close look the tube is just open on the other side of the shroud/panel so there is no dedicated...
I used this:
https://www.jaycar.com.au/10a-circuit-breaker/p/SF2258
For the sacrificial shaft I used this:
https://www.bunnings.com.au/metal-mate-12-x-1mm-3m-aluminium-round-tube_p1079420
Also here's my grain mill setup for dust control, works a treat but my dog hates me since I stopped...
Was from "another craft brewing forum" where someone suggested a thin walled alumnium rod from the big green shed as the shaft, secured with whatever. Idea is that the aluminium shaft itself was that soft that it would collapse/break in that event, rather than sizing a split pin.... I've...