Search results

I am glad you agree that your comment was inflammatory.

Argh you might be right Grmblz. But I hope not. Thanks duncbrewer. Nice set up. I’ll post a pic of the latest graph when I can.

Thanks again Rodney. Heating disabled before starting this brew. Yep I was thinking of turning fan on full time and see what difference it makes. Although the fermentation is slowing down now so there be less heat generated now too - potential confounding factor.

Question: Do you think the comment made by WEAL in hisreply that was deleted was relevant to this thread and/or was meant to be inflammatory? WEAL acknowledges this comment was the reason why his post was removed in post #57. I”d really like to continue a constructive conversation with out...

Hi Rodney. Yep, fan off as directed by KL. Heating disabled. True, the fermentation / co2 release is an agitator. But I’ve not observed such a discrepancy between temp measures with previous batches (Inkbird and other probes used concomitantly). I’ve never used a keezer before cos I saved all...

As mentioned earlier I think the extension probe should be mandatory with the unit. At least until you get your other rapt products sorted. Let the customer decide. I think it would be useful to have community testing to validate which probe type and position works best in this fridge...

A quick start guide is not a manual. The guide was useful to get the unit started / connected but that is all. it is otherwise bereft of essential information.

Firmware already up to date. Here's a screenshot of the temp. Up to 6 Oct the hysteresis was changed to 1 degree, and after that I reset it to the default 2 degrees for comparison. Any recommendations to reduce the temp swings and improve efficiency would be much appreciated. Note - I'm cold...

I have no doubt this fridge will be awesome, just needs some tweaking and good customer support.

I was also (lucky?) enough to score the RAPT fridge. Nice looking unit, good finish and well thought out extras such as incorporating spunding valve into front. I can report the same problem and concern as the OP. The unit temperature swings wildly. I have narrowed the hysteresis which reduced...

I will leave it up to Miran to make the call on that. I guess my point is that someone has expressed concerns, and the Moderator response was "Just accept the way he responds." I work in a very hierarchal industry where bullying is typically subtle and pervasive. Most of the time people are not...

This forum has a wealth of knowledge and good advice. But the cost of receiving that information should not be being belittled or vilified. The original poster made it clear that they did find these comments unpleasant. And they did this without resorting anger or abuse. As a fellow newIsh...

Ditto

I agree with both ideas.

Hi. I’ve sent a pm. Thanks

Great in ciders too

2. Enter and reply this post Done

Here’s a snap shot of the mini 360 On your website from today. Date back in is 29/7/20. On early 23/7/20 the back in stock date was 24/7/20. When I checked later that day the date had already changed to 27/7/20!! Then, again as mentioned above, on the Sunday 26/7/20 the date changed to 25/7/20...

It’s quite frustrating. Like the RAPT fridge...

Will that connect as ‘plug and play’ or would I need to cut and join wires? Thanks