Search results

Australia & New Zealand Homebrewing Forum

Help Support Australia & New Zealand Homebrewing Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. B

    iSpindel Digital Hydrometer

    I was thinking of going the Cherry Philip design as it seems slightly easier. Do you have the parts list required, at least a link to the smaller battery charger module required? Cheers
  2. B

    iSpindel Digital Hydrometer

    I'm trying to get the parts list, but it doesn't load. I suspect the shopping list has expired. Any chance you could send it again?
  3. IMAG0247

    IMAG0247

    servo motor to control gas valve
  4. IMAG0251

    IMAG0251

    Pilot light
  5. IMAG0248

    IMAG0248

    Valve for pilot light control
  6. Automated PID Biab

    Automated PID Biab

  7. 1376351 10152314589289799 3957206239779552664 N

    1376351 10152314589289799 3957206239779552664 N

    PID Automated BIAB System
  8. B

    Show us your brewrig

    G'day fellow brewers, I thought I would upload my automated gas PID BIAB system. It has been a long and somewhat painful process which at some point I thought was not going to be successful, but with a little persistence I finally got there :D If anyone is thinking of going down the...
  9. B

    BIAB Propane or heater element for mash temps?

    Thanks for the info guys, I may just give the sleeping bag a go. Where can you purchase a sheet of metallised rubber from?
  10. B

    BIAB Propane or heater element for mash temps?

    I did try it with a old blanket. It did manage to hold temps a lot better than using nothing. I do find it hard to put the blanket on with everything so hot and I am a little hesitant to put the blanket on while the burner is going for obvious safety reasons.
  11. B

    BIAB Propane or heater element for mash temps?

    G'day fellow brewers, I have recently had fluctuations in my mash temps for my BIAB system. I want to try and get the temp within 1-2 degrees during the mash stage. A little about my system: (see pic below) 1. I have been recirculating the wort from the bottom back through the top using a...
  12. control box

    control box

  13. shaft with coupling MKII

    shaft with coupling MKII

  14. grain mill

    grain mill

  15. Biab rig

    Biab rig

    My brew rig with grain mill
  16. Biab rig

    Biab rig

  17. B

    Comment by 'bradwhite087' in media 'STC-1000 jiffy'

    Better still Jaycar sell cable glands for about $6 Here is a link: http://www.jaycar.com.au/productView.asp?ID=HP0732 Great effort though!
Back
Top