Search results

Keep them for Bulk Buy grain splits.

What happens when you leave the reg at the set pressure, does it maintain the same pressure on the HP & LP side?

They are a much better keg than the std cornie keg.

I'm a bit late to the party, but my vote is for 500ml capacity cans and I have no preference for the top as I would be decanting to a glass. I think cans would be a great way to take my HB away bike camping as they are lighter, tougher, cool down quicker and easier to carry out when crushed.

Sounds interesting

I'm sure about that, I measured it as a 5/8" Brass thread (26 tpi)

Have a read of this and see if it helps http://www.dresselbrew.com/Keg_Info.htm

Yep, I dusted off my old Bucket'o'death to use as a HLT to sparge my new robobrew.

You should get it out and do a retro brew some day.

I only ever saw second hand units, never a new on in the shops so perhaps there were never sold here.

Hi Sean, that photo look pretty much like the old Bruheat kettles. Regards, Dave

Yes, it looks a bit like that German one. A narrow roller with a large diameter, only this one has a motor attached. Looks nice!

Hi, the three feet on the bottom of the screen should hold it above the tap. Are all three feet present on your unit?

Yes, and use the #2 flux with the hi silver content solder

Yes, the disconnect has a stop valve, when it not connected it will hold the pressure in the line.

It means you don't have any leaks in your gas line (that's a good thing). Press the pin in the grey disconnect and the pressure will drop.

Dry sand

Yeah a mill would be a lot more rigid.

I think a hole saw would be better than a drill. The drill could grab on the thin tube.