Braumeister Plus 50L, in near new condition. Only used for 5 brews.
$2200
Some very, very minor scratches on the exterior, and a few more inside the malt pipe from contact with a mash paddle. When I say minor, they are minor - barely visible.
All original parts included. Tap has been...
Good condition, includes all items pictured and listed below.
Small dent on bottom left of kegerator as pictured, and one of the Perlick taps is a little bit leaky so needs some new O-Rings
Cobra font was originally from a bar and was originally flooded, has had the bottom shaft cut to length...
30 plate heat exchanger
Dimensions 315 x 73 x 73mm
Good condition, thoroughly cleaned. Has some minor scratches on the surface, a very small ding on two corners of the bottom.
A barb on each end is also very slightly bent, this is how it came when I got it brand new.
RRP $129.99
Pick up...
Good condition, includes all items pictured and listed below.
Small dent on bottom left of kegerator as pictured, and one of the Perlick taps is a little bit leaky so needs some new O-Rings
Cobra font was originally from a bar and was originally flooded, has had the bottom shaft cut to length...
Braumeister Plus 50L, in near new condition. Only used for 5 brews.
$2900
Some very, very minor scratches on the exterior, and a few more inside the malt pipe from contact with a mash paddle. When I say minor, they are minor - barely visible.
All original parts included. Tap has been...
Braumeister Plus 50L, in near new condition. Only used for 5 brews.
$3600
Some very, very minor scratches on the exterior, and a few more inside the malt pipe from contact with a mash paddle. When I say minor, they are minor - barely visible.
All original parts included. Tap has been...
Located in Pyrmont for pickup. Can post the false bottom and ball valves, and could post the c02 bottle via road freight
4 x Corny Kegs - $180 - will only sell in lot of 4
Need a bit of repairing. One of them holds pressure no worries, but 3 have very slow leaks out the gas post. They are fine...
Have my kegerator set to -4c, and it displays -4c pretty constantly, however the actual temp is nowhere near this cold.
Anyone know where the probe is, and if its movable?
Any other mods to keep it cooler?
I'd put a temp controller on it, however every time the kegerator turns on it beeps...
Yeh I used beersmith.
Filled with 55L, 12kgs g normal mash schedule starting at 58c ending at 78c in different steps over 90 mins (45 mins at 62c).. Pulled out malt pipe, topped back up to 55L. Boiled, and then topped up to 55L again at end of boil.
The fine crush is all I can think could be...
Got the 50L braumeister recently.
I've done two brews so far with horrible results. Woeful efficiency...
First brew:
11kgs of grain. 50L into fermenter. Aiming for 1.052Came in at 1.043... 65%. Was a bit disappointed with this. I thought my crush might not have been great, so for the second...